Main features of solid-liquid separator:

The whole machine has compact combination, low energy consumption, stable operation, high degree of braking, and good solid-liquid separation effect. After using the separator, the removal rate of suspended solids in sewage can reach more than 90%, and the water content of excrement residue after extrusion is less than 60%, and no secondary pollution will be generated. The feces can be directly packaged and transported, and can also be used as fishing bait. It is suitable for the harsh environment with high humidity and strong corrosiveness. It is a solid-liquid separation equipment for feces.

What is the reason for the heating of the bearing of the solid-liquid separator?

First of all, users should pay attention to the smoothness of the machine and choose good high-temperature lithium-based grease, because the difference of lithium-based grease is also another reason for bearing heating. If during the inspection process, mechanical friction will be accompanied by noise, mechanical parts will be significantly worn, and the bearing will be loose, it should be a bearing problem, and the bearing needs to be replaced.

2. The concentricity of the main shaft tends to be large, and the force on the bearing is uneven, which easily causes the bearing to heat up.

3. Whether the concentricity of the main shaft of the solid-liquid separator is accurate. Under normal circumstances, people do not pay much attention to the concentricity. The concentricity of the main shaft tends to be large, and it is very simple to form bearing heating. When a machine is overloaded or overloaded, the spindle is stressed beyond its acceptable level, causing the bearings to heat up.

4. Overload may be overloaded. This may be a problem such as the cooling fan, or it may be the heat generated by mechanical friction, but the first question is whether the bearing is authentic. Because some users buy low-priced bearings at low prices, the bearings heat up and cause the bearings to burn out. If the bearing lubricating oil is insufficient or the lubricating oil is insufficient, the friction force will be large during operation, which will also cause the bearing to heat up.

Common faults and solutions of solid-liquid separator:

1. Abnormal discharge

In this case, we should choose the response method according to different models. For example, if it is a counterweight hammer, we need to adjust the position of the counterweight hammer. If the spring is compressed, we need to adjust the tightness of the spring, so that it is easy to fix the problem of abnormal discharge.

2. The material is too thin

This situation is usually due to the blockage of the filter screen, and the water cannot leak through the filter screen in time. At this time, the filter screen should be cleaned in time. If the outlet pressure is increased blindly, the filter screen may be damaged.

3. The feed port is not loaded

This situation may be that the feed port is blocked or the feed pump is damaged. In this case, it is necessary to treat it differently, replace the feed pump or clean the feed port.

Specific problems are dealt with in detail. The above three problems are common and easy to repair for solid-liquid separators. The working process of pig manure solid-liquid separators is described below to facilitate understanding of problem solutions.

1. The conveying screw pushes the material entering the feed box to the extrusion screw. By reducing the pitch of the extrusion screw and increasing the shaft diameter, the liquid substance contained in the material is extruded under the action of the resistance of the screen wall and the cone. (juice).

2. The extruded liquid flows out from the sieve hole and gathers in the water receiving bucket.

3. The squeezed liquid is discharged through the discharge machine between the end of the screen cylinder and the cone. A pressure counterweight is mounted behind the cone. The slag discharge resistance and the size of the slag outlet can be changed by the preload and position of the pressure counterweight hammer, and the dry humidity of extrusion can be adjusted.

If your company wants to establish a business relationship with us, please briefly describe the cooperation intention and send an email to：chuantaiscrewpress@gmail.com