The specific operating steps of the screw press dehydrator are as follows:

1. Before feeding the screw press dehydrator, the cone and feed port should be closed, and the pressure spring torque should be adjusted appropriately according to the nut. When the slag skin causes slag resistance, check the pressing effect, and then appropriately adjust the clamping level and position of the yellow spring to achieve a satisfactory pressing effect.

2. When feeding the screw press dehydrator, dirt and other items should be prevented from entering the device. Thicker branches should be removed to prevent damage to the screen cylinder. The feed should be as symmetrical as possible to achieve better actual results.

3. After the screw press dewatering machine is finished squeezing, the pressure spring should be released in advance so that the cone moves under the push of the pomace. The pomace behind will be pressed too hard, which is conducive to elimination. When not needed for a long time, the equipment should be cleaned and vegetable oil should be applied to rust-prone areas for maintenance.

The screw press dewatering machine is inseparable from waste water and sludge during the entire operation process. These two compounds are very harmful to bearings, and the selected bearings should be wear-resistant. In addition, sealing and lubrication should also be achieved. details as follows.

1. If the bearing is found to be damaged, it should be replaced immediately. When installing new bearings, they must be standardized and careful and must not be lost. Avoid damaging bearings, avoid printing stress and cracking.

2. During the entire process of using mechanical equipment, pay attention to the anti-rust treatment of the bearings and avoid getting too much water. Clean around the bearing seat, apply lubricant, and perform maintenance.

Introduction to the use of screw press dewatering machine:

1. Before feeding, the cone and discharge port should be closed, and the preload force of the pressure spring should be adjusted appropriately through the nut. When the slag skin forms slag resistance, check the compression effect, and then appropriately adjust the compression degree and position of the spring to achieve a satisfactory compression effect.

2. When feeding, foreign matter and other things should be prevented from entering the machine. Pay special attention to removing branches with a diameter exceeding 8mm to avoid damaging the screen cylinder. Feeding should be as uniform as possible for better results.

3. At the end of squeezing, the spring should be relaxed in advance so that the cone moves under the push of the pomace, and the pomace behind will not be compacted, making it easier to remove. When not in use for a long time, the machine should be cleaned and the rusted parts should be protected with oil.

4. Regularly add lubricating oil or grease, such as transmission systems and transmission components, bearings, etc. When working, attention should be paid to the temperature rise not exceeding room temperature 35.5C.

The screw press dehydrator can process biomass fuel, food waste and domestic waste, production and processing of fruits and vegetables, pericarp residue, food crop straw, biogas residue, green plant straw, livestock and poultry manure sewage, paper pulp, and raw pulp paper , sugarcane bagasse, residue, wine trough, vegetables and fruits, sawdust, traditional Chinese medicine residue, plastic waste, paint residue, potato residue, tapioca starch, maltitol, straw pulp, cotton pulp, leaf residue, seaweed, bamboo pulp, seaweed, water hyacinth , corn stalks, furfural residue, rice husks, cottonseed hulls, hydrogenated acids, livestock and poultry extrusion deoiling, green plant underground stems, paper industry waste residue, waste paper pulp.

If your company wants to establish a business relationship with us, please briefly describe the cooperation intention and send an email to：chuantaiscrewpress@gmail.com