In order to ensure the normal use of the screw press separator, it must be cleaned and inspected in time. After the press is finished every day, it should be cleaned in time and the site should be inspected:

1. Check the cleanliness inside the machine.

2. Check the cleanliness of the filter belt.

3. Check the quality of the filter belt. (check for damage)

4. Check the automatic control function of the filter belt operation. (whether sensitive and reliable)

5. Check whether the water outlet of each liquid collection tank is blocked. If there is any phenomenon, stop the machine, rinse and dredge it in time.

6. After the mud is discharged every day, the filter belt flushing is delayed for 30 minutes, and the screw press is cleaned with a flushing water hose to complete the cleaning of the entire equipment.

What are the main application fields of the screw press separator?

The screw press separator is used for daily wet garbage, kitchen waste, end vegetables, fruits and vegetables, residues, raw pulp paper, starch residue, slaughter straw pulp, maltitol, bean curd residue leucorrhea, bandaging, etc. Slag liquid with high concentration value is separated. The material enters the new-type screw continuous extruder from the feed port, and the diameter of the pitch circle of the screw guide roller decreases from width to width, and the guide roller groove changes from deep to shallow. Therefore, the pressure of the material gradually increases during the exercise, and the material liquid is separated out of the mesh by the stainless steel plate, the separated liquid is discharged from the bottom and the outlet inside the guide roller, and the extruded material is discharged from the feed inlet. This mechanical equipment is mainly composed of motor shaft, screw shaft and drying system (spherical grid and stainless steel plate separation net), and is composed of reducer, motor and so on.

The equipment has a special smoothness, and the roller surface creates a continuous spiral slope. As the diameter of the indexing circle and the depth of the groove decrease from the feed to the cast iron at the feed end, the material moves forward along the spiral groove, the material is continuously squeezed in the axial direction and latitude, and the liquid is continuously separated according to the dehydration system. Non-uniform separation equipment for press processing, high level of automation technology, simple operation process, convenient maintenance, large daily output, low driving force consumption, suitable for continuous work. Its key components are made of stainless steel plates.

What problems should be checked in advance before using the screw press separator?

1. Before feeding the screw press separator, the cone and the feeding port should be closed, and the torque of the pressure spring should be properly adjusted according to the nut. When the slag skin produces slag resistance, check the actual effect of squeezing, and then properly adjust the clamping level and position of the yellow spring to achieve a satisfactory squeezing effect.

2. When feeding the screw press separator, dirt and other items should be prevented from entering the device. Thicker branches should be removed to prevent damage to the screen drum. The feeding should be as symmetrical as possible to make the actual effect better.

3. After the screw press separator squeezes, the pressure spring should be released in advance, so that the cone moves under the push of the pomace, and the pomace behind is pressed too hard, which is conducive to elimination. If it is not needed for a long time, the equipment should be cleaned, and the rust-prone parts should be coated with vegetable oil for maintenance

If your company wants to establish a business relationship with us, please briefly describe the cooperation intention and send an email to：chuantaiscrewpress@gmail.com